04
LiteRadio 3 radio transmitter has a built-in 2000mAh b . When the red light
s twice and the buzzer alarms twice, indicates that radio transmitter is low
b
e-charged. Below charging method for reference:
● Turn o
adio transmitter.
● Plug in radio transmitter with adapter by USB cable (5V output adapter is
allowed).
● The LED ring breathes in red means charging, while in green means fully charged.
6.Charging
Note: LiteRadio 3 CC2500 version only work with D16 ACCST 1.X Frsky protocol. So if you use a
Frsky receiver with D16 ACCST 2.X version or ACCESS version, binding will fail.
To change protocols and TX module, here are the steps:
1. Power the radio transmitter o
2. Press and hold the BIND button while power the radio transmitter back on;
3.
s of the LED before buzzer alarms will change,
according to the tables above.
Red Flash once
Internal Frsky D16 FCC (ACCST 1.X Version)
LED Status
Protocol Version
Red Flash twice
Internal Frsky D16 LBT (ACCST 1.X Version)
Red Flash Three Times Internal Frsky D8
Red Flash Four Times Internal Futaba S-FHSS
Purple Flash Three Times Quickly
Internal
ternal TX Module
Red Flash once Internal ELRS
LED Status
Protocol Version
Purple Flash Three Times Quickly
Internal
ternal TX Module
ExpressLRS Version
Cc2500 Version
To Next Page
Loading...
Need help?
General
