BETAFPV LiteRadio 3 User Manual

02
1.Button Functions
● Power Button: Turn the radio transmitter o on.
There are three buttons on LiteRadio 3 radio transmitter.
● BIND Button: Enter binding mode after radio transmitter is powered on.
● SETUP Button: Enter joystick calibration mode after radio transmitter is powered
on.
2.Pow
POWER ON: Long press the power button on the radio transmitter for 3 seconds
until it beeps three times (do re mi) then release. The radio transmitter LED ring will
ed quickly, then remain blue.
POWER OFF: A long press of the power button on the radio transmitter will turn it
o
ter three beeps (mi re do).
3.LED Indicator and Buzzer
The LED ring indicates the working status of the radio transmitter.
The back side of the radio transmitter.
SETUP
BIND
Audio P
Type-C P
NANO Bay
NC
VCC
GND

BETAFPV LiteRadio 3 Specifications

General

Frequency Range	2.4GHz
Screen	No
Voice Support	No
Support USB Simulator	Yes
Firmware Upgrade Method	Via USB
RF Power	100mW
Display	No
Protocol	Frsky
Compatibility	Frsky, Futaba
Gimbal Type	Hall sensor gimbals
USB Port	USB Type-C
Channels	8 Channels
Battery	Built-in 2000mAh 1S Battery