BC01
Instruction Book Of BC01 cable to cable
12
7.4. If the connector to be disassembly for rewire, please according to the following steps:
7.4.1. Loosen tail parts (End Locker, Wire Sealing Claw and Wire Sealing body);
7.4.2. Use a suitable flat screwdriver to press the elastic tongue on the male or female cable
body inward and push forward slightly, and when the tongue comes off a little,use the same method
to the tongue on other side.Give a force along the axial direction until separation.
8. Maintenance
The user should do maintenance work according to the different operating environments and
frequencies. If discovering any damage of connector systems, please stop using and change it
immediately. Please do not separate and mate the connector system frequently if not for repairing or
maintenance reason which may reduce the waterproof performance of the system.
To Next Page
Loading...