Betz WAVE - Setting Up Motor Power

The basic setting for the motor power is fine for a wide range of camera weights.
If the power is adjusted too strong you will feel it in jerkily movements or a vibration.
If the power is adjusted too weak you will see it in creeping movements to the end point.
The motor power can be adjusted very easily as follows.
Adjustment Knob
USBSD-Card
Horizon
Setup
max.
POWER
CAN
LOCKED
M
-PO
W
ER
RAM
P
TILT ANGLE
SET UP Motor Power
Push Button Setup Push Button Setup Push Button Setup Push Button Setup 3 sec. Push Button Setup
Red flashes
set M-Power via Poti
Green
Tiltangle
short flashing
M-Power stored
All LEDs on
Menu started
Red
Setup M-Power
Setup
RAMP
M-POWER
max.
POWER
CAN
LOCKED
M
-PO
W
ER
RAM
P
TILT ANGLE
POWER
CAN
LOCKED
M
-PO
W
ER
RAM
P
TILT ANGLE
POWER
CAN
LOCKED
M
-PO
W
ER
RAM
P
TILT ANGLE
POWER
CAN
LOCKED
M
-PO
W
ER
RAM
P
TILT ANGLE
POWER
CAN
LOCKED
M
-PO
W
ER
RAM
P
TILT ANGLE
Push Button