Trouble Shooting
Power LED flashes / Locked LED flashes 1/2/3/4 or 5 times switch off Wave and restart after about 5 sec.
If the error remains contact the manufacturer.
Power LED continously flashes. Switch off Wave and restart after about 5 sec.
Wave stops in one direction far from the endstop or the Horizon can‘t be adjusted to the level.
The IMU has lost for some unknown reason the ”zero position”.
Preperation for recalibrating the ”zero position” :
It is very Important that the power supply is designed for 3 Amp. at 14 Volt.
It is very Important that the Wave is placed on a solid and horizon oriented level surface.
The camera quicklockplate has to be placed in mechanical ”zero position” and the Lok Pin
is not be locked. Power supply is switched off.
Calibrating Set up ”zero position”
- Push button ”Set up” and hold, switch on power supply.
- Push button while the green and blue LED is permanent on.
- Release Push button the electronic ”zero position” will now be adjusted.
- Red LED flashes fast, engage Lok Pin, red LED is permanent on.
- Wave determines now the mechanic ”zero position” and stores it into the memory.
- Wait until green LED flashes slow and the red LED is permanent on.
- Setup is now finished switch off power supply and restart the Wave.
Warning! Disassembling the Wave will result in the unit having to be returned to the manufacturers
for an electronic and mechanical rest.
To Next Page
Loading...