20
9. Cleaning and maintenance
The device should be cleaned from time to time.
This should be done using a damp cloth and, if necessary, a small amount of detergent.
IMPORTANT
• Never use abrasive solvents or cleaning products!
• Never submerge the device in water!
• Do not clean the device in a dishwasher!
10. What if there are problems?
If the scale encounters an error during measurement, the following is displayed:
Display Cause Solution
U - Unknown measurement as it
is outside the user assignment
limit or a unique assignment is
not possible.
Select your user by pressing the
/
buttons.
BF Err The proportion of fat is outside
the measurable range (less
than 3% or greater than 65%).
Please repeat the measurement barefoot, or
with the soles of the feet lightly dampened
if necessary.
oLd Maximum weight capacity of
200 kg exceeded.
Loads must not exceed 200 kg.
Incorrect weight is dis
-
played.
Surface scale is placed on is
not even and hard e.g. carpet.
Place the scale on an even, hard surface.
Incorrect weight is dis-
played.
Not standing still. Stand as still as possible.
Incorrect weight is dis-
played.
Incorrect zero point of scale. Wait until the scale switches itself off. Acti
-
vate the scale, wait for “0.0 kg” to appear
and take the measurement again.
Lo The batteries in the scale are
flat.
Replace the batteries in the scale.
BF - - - BIA measurement not possible. Please repeat the measurement barefoot, or
with the soles of the feet lightly dampened
if necessary. Remain on the stainless steel
electrodes after weight measurement, until
the body analysis values are displayed.
11. Disposal
Empty, completely flat batteries must be disposed of through specially designated collection boxes, recy-
cling points or electronics retailers. You are legally required to dispose of the batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury
For environmental reasons, do not dispose of the device in the household waste at the end of its service
life. Dispose of the device at a suitable local collection or recycling point in your country.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.
Dispose of packaging in an environmentally friendly manner.
20
To Next Page
Loading...
