EasyManua.ls Logo

Beurer BR 90 - Device Operation Completion

Beurer BR 90
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36
5. If required, you can use the heat function of the insect bite healer on
the sting/bite again after a break of 2 minutes or also use it immediately
on another sting/bite in a dierent area. The maximum number of 5 ap-
plications per hour on the same treatment area must not be exceeded.
6. If the device is no longer required, set it to “OFF” again using the ON/
OFF switch
2
. This is indicated by the “O” symbol. The blue device
status LED
6
turns o.
7. Before storing, make sure that the device is switched o and the heat-
ing plate
3
has cooled down.
Battery warning
Before the battery level becomes too low for other applications, the device
status LED
6
starts to flash 3x and an acoustic signal sounds 3x. Replace
both batteries soon, as described in section 6.
8. CLEANING AND MAINTENANCE
Observe the following hygiene instructions to avoid health risks:
• The device is intended for multiple uses.
• It is recommended that the device is cleaned before first use and each
additional use.
• The device must be switched o, allowed to cool down and the batter-
ies removed each time before cleaning.
• Use only soft, dry cloths for cleaning the housing.

Table of Contents