8 9
Note
You can position the universal cu on either your knee
or elbow.
Before positioning the universal cu, first clean the body
parts to be treated.
Make sure that you can access the control unit and the
universal cu quickly during the treatment so that you
can stop the treatment promptly if it is unpleasant
Before positioning the universal
cu, first moisten the water contact
electrodes and the knee/elbow with
water.
Position the universal cu on your knee or elbow. At this point,
ensure that the surfaces of the water contact electrodes sur-
round the knee/elbow. In doing so, the round opening of the
universal cu must lie on the kneecap/elbow tip.
2. Fix the universal cu in the desired
position using the hook-and-loop
fasteners. Ensure that the universal
cu is not too tight but that the wa-
ter contact electrodes still have suf-
ficient contact with the skin.
3.
Insert the plug for the connection
cable into the connector socket [5]
on the control unit.
Replacing the battery
Please replace the batteries when the battery status
symbol appears in the display [7].
• Open the battery compartment [4]
by pushing the cover in the area
marked with an arrow and sliding
downwards.
• 3 x 1.5 V batteries, type AAA (LR
03 Micro) should be inserted for
operation. Ensure the polarity is
correct. Observe the graphic in the
battery compartment.
• Do not use rechargeable batteries.
6. OPERATION
General notes on use
Do not switch on the device until the cu is correctly
positioned. See chapter 5.
To Next Page
Loading...
