Beurer EM44 - Before First Use; Initial Setup Procedure

12
8. Before First Use
1. Remove the belt clip from the unit (if attached).
2. Remove the battery compartment cover on the rear of the device by sliding it in the
direction of the arrow.
3. Insert three „AAA“ alkaline batteries in accordance with the polarity markings inside the
compartment.
Fig.
2
Fig.
1
Fig. 3
Fig. 4
Fig. 2
Fig. 1
Fig.
3
Fig. 4
4. Reattach the battery compartment cover. (Fig.1)
5. Attach the belt clip, if desired.
6. Attach the electrodes to the cables. (Fig.2)
7. Insert the plugs of the cables into the sockets on the top of the device. (Fig.3)
Do not pull, twist or make sharp bends in the cables. (Fig.4)
NOTE:
When the batteries are replaced or removed, all settings are restored to the factory defaults.