Beurer HT 22 - Cleaning and Maintenance

17
3. Switch on the device using the ON/OFF button
2
. Use the
ON/OFF button
2
to select the correct direction of use. The
correct direction of use depends on which hand you are us-
ing or which side of your head you are using the device on.
The green arrows in the display
1
should point towards the
floor during use.
4. Part the hair into individual sections that are approximately
2 to 3 cm wide.
5. Hold a section taut and place it between the plates near the
roots (see Figure
C
).
6. Slowly move the device from the roots to the tips in a fluid
motion (see Figure
D
). Dry and broken hair tips are cut o
and land in the collection tray
5
.
7. To switch o the device, press the ON/OFF button
2
until
the green arrows disappear from the display.
8.
Press the two plates together and slide the plate locking
system
3
upwards.
5. CLEANING AND MAINTENANCE
WARNING
Risk of injury/crushing! Switch o the device before removing
the collection tray
5
from the device. Do not reach into the
cutting chamber from behind while the device is switched on!
1. Slide the collection tray
5
on. Clean the collection tray
5
and cutting chamber
4
with the cleaning brush after each
use.
2. The device housing can be cleaned with a soft cloth damp
-
ened with warm water.
3. Your device is maintenance-free.
4. Protect the device from dust, dirt and humidity.
5. Do not clean the device in the dishwasher.