24
8. Move the curl styler along the hair, stopping just
before you reach the roots. Hold the curl styler in
this position. Make sure that you do not touch your
scalp or hands with the heating rods [2].
9.
Rotate the curl styler 360° and slowly pull it down
along the entire section of hair. Make sure you
keep the curl styler at the same angle to prevent
the hair overlapping.
Note: After 30 minutes the device switches into
stand-by mode (100°C). After 45 minutes the
device switches o automatically. The LCD tem
-
perature display [3] flashes to indicate this.
6.2 After application
1.
To switch o the curl styler after use, hold down the ON/OFF button [6] for three seconds.
Make sure to deactivate the keylock beforehand. “OFF” appears on the LCD temperature
display [3]. The curl styler is now switched o.
2. Pull the mains plug out of the socket after each use. Do not wind the mains cable around
the device!
3.
Place the curl styler on a stable, horizontal and non-flammable surface to cool down. Make
sure that the hot heating rods [2] do not touch the surface! Risk of fire!
4. Wait until the heating rods [2] of the curl styler have cooled down completely. Then store
the curl styler in a dry place out of the reach of children. Alternatively, you can hang up
the curl styler on a hook using the hanging eyelet [9].
To Next Page
Loading...
