EasyManua.ls Logo

Beurer HT 75 - Device Description; Usage; Preparing for Use; Starting Use

Beurer HT 75
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
•
Risk of fire! Place the device on a non-flammable surface only�
•
Risk of fire! The device must not be covered�
•
Risk of fire! Do not use the device on artificial hair�
•
Risk of burns and fire! The device can become very hot� When the
device is hot, it must only be held using the handle
7
�
4. DEVICE DESCRIPTION
The associated drawings are shown on page 3�
1
Cool-touch tip
7
Handle
2
Ion outlet
8
Temperature display
3
Support legs
9
Temperature button
4
Heating rod
10
ON/OFF button
5
Anti-clockwise rotation button
11
Swivel joint
6
Clockwise rotation button
12
Mains cable
5. USAGE
Preparing for use
1� Fully dry your hair before using the curling tongs�
2� Make sure that your hair is clean and free from styling products� This does not apply to products which
protect the hair against heat�
3� Comb your hair with a large-toothed comb to get rid of any tangles�
4� Stand on a dry, non-conductive surface� Dry your hands thoroughly�
Starting use
1�
To switch on the curling tongs, press and hold the ON/OFF button
10
for two seconds� The curling
tongs show the currently set temperature setting in the temperature display
8
� The ion outlet gently
emits the ions�
2�
Use the temperature button
9
to select your desired temperature setting (170°C, 190°C or 210°C)� The
selected temperature setting flashes in the temperature display
8
� As soon as the curling tongs have
reached the selected temperature, the temperature display
8
lights up permanently� The curling tongs
are now ready for use� We suggest the following temperature settings for your hair type:
Temperature setting Hair type
170 °C Fine, brittle, coloured or bleached hair
190 °C Normal hair
210 °C Thick and resistant hair
3� Separate your hair into individual sections with a width of approx� two centimetres� Hold the sections
taut at the tips�
4� Carefully guide the sections as shown (see drawing
A
on the fold-out page) into the slot between the
two heating rods
4
� Make sure that the temperature display
8
is facing you� Make sure that you leave
enough space between your hand and the heating rods
4
�