Beurer LB 44 - Initial Use

14
1. Mist outlet
2. Recessed grip
3. Water tank
4. Water tank screwed plug
5. Water basin
6. Base unit for air humidifier
7. Fill level sensor
8. Ultrasound membrane
9. Control dial
10. LED display
11. Mains cable
12. Aroma compartment
Principle behind the LB 44 air humidifier
1 High-frequency vibrations release tiny drops from the surface of the water.
2 The fan air flow transports the humid air out into the room.
3 Water evaporation can also be switched on.
4 If you wish, the device can be used with aromas.
5. Initial use
Unpacking the device
WARNING
Keep packaging material away from children! There is achoking hazard.
•
O pen the cardboard packaging.
•
R emove the protective insert.
•
K eep the plastic film closed.
•
L ift the device up and out of the packaging.
•
R emove the plastic covering.
• C heck the device, the mains plug and the cable for damage.
Installation location
WARNING
Before putting the device into operation, read the safety notes in the Safety chapter.
Note
• T he immediate vicinity of the air humidifier can become damp.
•
C alcareous water can leave white deposits.
•
D o not place the device on the floor, but in araised position (e.g. on atable or chest of drawers).
•
P osition the device so that the mist outlet is not directed towards objects.
•
E mpty any remaining water when the device is not in use.
•
P lace the air humidifier on afirm, level and water-resistant surface.
If the device should accidentally tip over, water may escape, even if the device is switched off and un
-
plugged.
12