Beurer LB 44 - Technical Data; What if There Are Problems

18
9. What if there are problems?
Problem Cause Solution
No LED display The mains cable is not plugged
in.
Connect the plug.
The control dial is at its minimum
position.
Turn the control dial clockwise towards the
maximum position.
Red LED
The water level is too low; the
water tank is empty.
Fill the water tank.
No mist is produced The LED lights up green.
Turn the control dial clockwise towards the
maximum position.
The LED lights up red. Fill the water tank.
The LED display does not light
up.
Connect the plug.
The mist has a strange
smell
The device is new. Remove the water tank, turn the screwed
plug and remove it.
Air the open, emply water tank in acool,
dry place for twelve hours.
Stale or dirty water.
Empty the base unit and the water tank and
clean them thoroughly.
Fill the water tank with fresh water.
Strange noise The water tank is not positioned
correctly on the base unit.
Lift up the water tank and position it cor-
rectly on the base unit.
The tank should sit tightly on the base unit.
Strange noise There is too little water in the
water tank.
Fill the water tank.
The device is not level and un-
stable.
Place the device on afirm, level surface.
Mist escapes underneath
the water tank
The water tank is not positioned
correctly on the base unit.
Lift up the water tank.
Check whether the join between the base
unit and water tank is clean.
Clean if required.
Position the water tank correctly on the
base unit.
The tank should sit tightly on the base unit.
10. Technical data
Dimensions (LxWxH) approx. 25cm x 12cm x 34cm
Cable length approx. 1.5m
Weight when empty approx. 1.5kg
Mains voltage/frequency 100 – 240 V AC / 50/60 Hz
Nominal power 20watts
Room size up to 25m²
Capacity approx. 2.8litres
Evaporation output 220ml/hour
Signs and symbols
The unit is double-protected and thus corresponds to protection
class 2.