Beurer LB 44 - Page 16

16
Every three days As required
x Clean the ultrasound membrane with abrush, rinse the base.
x Rinse the water tank, replace the water.
x Clean the air intake filter on the underside.
x Clean the air humidifier inside and out.
x Descale.
WARNING
The device must be switched off after every use and before cleaning. Pull the plug out of the mains socket.
IMPORTANT
The water tank must be cleaned and the air humidifier completely emptied if the device has not been used
for over aweek.
Note
• C lean the device using only the methods specified.
•
U nder no circumstances may liquid enter the base unit.
•
D o not use any solvent-based cleaning products.
•
O nly use amild flushing agent or vinegar/vinegar-based cleaner to perform cleaning or disinfection work.
Cleaning the ultrasound membrane with abrush, rinsing the base
Note
Empty the water from the base unit via the side rim in the direction in-
dicated by the arrow. Ensure that no water gets inside the device, e.g.
via the fan opening.
•
C lean the ultrasound membrane using the cleaning brush provided.
•
E mpty the water from the base unit via the side edge.
•
O bserve the markings on the device!
•
S hould dirty residue remain in the base unit, pour some clean, fresh
water into the base unit and empty it out via the side edge.
Rinsing the water tank, replacing the water
• C lean the water tank regularly, at least once aweek if using daily.
•
U se amild cleaning agent or vinegar/vinegar-based cleaner.
•
C lean the thread of the screwed plug using asoft brush.
•
H alf-fill the water tank with water.
•
T ightly close the water tank using the screwed plug.
•
S hake the water tank by rocking it back and forth several times.
•
E mpty out the water completely.
•
R epeat the process using clean, fresh water.
Cleaning the air intake filter
• E mpty the water from the base unit via the side edge.
•
D ry the base unit.
•
R emove the air filter on the underside of the base unit from its holder.
•
C arefully rinse out the air filter with water and leave it to dry.
•
I nsert the dried air filter into its holder on the underside of the base unit.