19
The device can be switched on by pressing
the ON/OFF control
4
again.
When the device is connected to
the power supply, the travel lock is
automatically deactivated so that
the device can be used in mains
operation right away.
7. USAGE
1.
Place the stainless steel blade
1
onto the
device from above until it clicks into place.
To remove the stainless steel blade
1
again, press it upwards with your thumb.
100.58_MN5X_2023-07-24_01_ put-on-attachment _BEU
100.58_MN5X_2023-07-24_01_remove-attachment_BEU
2.
If necessary, select one of the six comb at-
tachments
2
and place it on the stainless
steel blade
1
. Slide the comb attachment
2
as far as it will go along the stainless
steel blade
1
. We recommend that you
start with the comb
attachment with the
longest cutting length
initially so you can
then slowly work your
way up to your desired
length.
3.
Press the ON/OFF control
4
to switch on
the device. The LED display
5
begins to
light up.
4.
Guide the device slowly through the hair.
Ensure that the comb attachment sits as
flat on the head as possible. Always only
trim small areas. Cut the hair against the
direction of growth. If the hair grows in dif-
ferent directions, use the device in multiple
directions.
5.
To switch o the device after use, press
the ON/OFF control
4
. The LED display
5
turns o.
8. CLEANING AND
MAINTENANCE
8.1 Cleaning the device
WARNING
•
Risk of electric shock! Always disconnect
the device from the power source before
cleaning it.
•
Risk of fire! Do not clean the device with
highly flammable liquids!
•
Do not clean the device in the dishwash-
er!
•
The device is not waterproof. The stain-
less steel blade
1
can be removed and
rinsed under running water for hygienic
cleaning.
1.
For thorough cleaning, remove the stain-
less steel blade
1
from the device by pull-
ing it upwards.
2.
Leave the stainless steel blade
1
to dry
completely before reattaching it to the de-
vice.
8.2 Oiling the stainless steel
blade
To achieve consistently optimal cutting re-
sults, spread a little cutting oil on the stainless
steel blade
1
on a regular basis.
9. ACCESSORIES AND
REPLACEMENT PARTS
To purchase accessories and replacement
parts, please visit www.beurer.com or contact
the corresponding service address (according
to the service address list) in your country.
Accessories and replacement parts are also
available from retailers.
100.58_MN5X_2023-07-24_01_put-on-comb_BEU
To Next Page
Loading...