Beurer MN9X - Device Setup and Operation; Usage and Charging Procedures

18
5. DEVICE DESCRIPTION
The related illustrations are on page 3.
1
Beard trimmer
2
2 comb attachments for the beard
trimmer (3-7/8-12 mm)
3
Hair clipper
4
4 comb attachments for the hair clipper
(3-12 mm)
5
Nose/ear hair trimmer
6
Precision trimmer
7
Body groomer
8
2-level precision adjustment: 0.8 and
1.2 mm
9
ON/OFF controller
10
LED display with battery status in %
and charge display
11
Connection socket
12
Hard case
13
USB charging cable
14
Cutting oil
15
Cleaning brush
6. INITIAL USE
You must fully charge the battery for 90
minutes before the first use. The operating
period of the device is approx. 90 minutes
when it is fully charged.
If the battery charge level is less than 20%,
the LED display will show
10
“Lo” for “Low”
and flash.
1.
Connect the USB charging cable
13
to the
connection socket
11
and a mains adapter
(not included in delivery). To charge the
device, only use a protection class 2 mains
adapter ( ), which is approved for use
with household appliances and whose
output corresponds to the safety extra-
low voltages of 5 V and max. 1 A.
2.
Insert the mains adapter into a suitable
socket. The LED display
10
shows the
current battery status in % and the charge
display flashes.
3.
The battery is fully charged once the
LED display
10
shows “100%” and
the charging symbol is permanently
illuminated. The device is now ready for
use.
7. USAGE
7.1 Beard trimmer
1. Place the beard trimmer
1
onto the
device from above until it clicks into place.
To remove the beard trimmer
1
, press it
upwards with your thumb.
102.60_100.57_MN4X_MN9X_2023-06-23_01_put-on-beard-attachment_BEU
102.60_100.57_MN4X_MN9X_2023-06-23_01_remove-beard-attachment_BEU
2. If necessary, select one of the two comb
attachments
2
and place it on the beard
trimmer. Make sure that you hear and feel
the comb attachment click into place. We
recommend that you start with the comb
attachment with the longest cutting length
initially so you can then slowly work your
way up to your desired length.
3.
To adjust the cutting
length, slide the
comb attachment
2
upwards or
downwards.
4.
To switch on the device, slide the ON/OFF
controller
9
upwards. The LED display
10
will start to light up.
mm
102.60_100.57_MN4X_MN9X_2023-06-23_01_put-on-beard-comb_BEU