6
4. To Use
1
. Select an attachment and gently push it onto the spindle. To remove, pull
the attachment straight out.
2
. Switch the device on by sliding the power switch back for a counterclockwise
rotation (the Power LED will illuminate in red) or forward for clockwise
rotation (the Power LED will illuminate in green).
3
. All file and cutting attachments are coated with a sapphire grain. This
ensures long life. Do not exert heavy pressure and always guide the
attachments carefully in circular movements slowly over the parts to be
treated.
4
. Press the Speed Buttons (+ and –) to select a rotation speed. Start every
treatment at low speed and increase only as required.
5
. Always ensure that the spindle can rotate freely. It must never be permanently
jammed; otherwise, the instrument will become too hot and suffer damage.
6
. Blue Speed Indicator LEDs will illuminate to indicate the selected speed
from one to five.
7
. Check the results during treatment. This is particulary important for diabetics,
since their hands and feet are less sensitive.
8
. After every use, apply moisturizing cream to the parts treated.
5. Attachments
S
ince the attachments are of a high quality and improper use can lead to injury,
handle the attachments carefully. Use extra caution when operating the device
at high speeds.
T
he following attachments are provided with your appliance:
1 – Flame milling cutter
Removes ingrown nails. Carefully guide the flame
cutter over to the treatment area in order to remove
parts of the nail as necessary.
2 – Cylindrical milling cutter
Grinds and smooths lignified foot nail surfaces.
Apply the milling cutter horizontally to the nail
surface and remo ve the unwanted layer of nail using
slow circular movements.
To Next Page
Loading...
