Beyerdynamic AMIRON WIRELESS - Playback Device Settings for Best Wireless Sound

Amiron wireless – Headphones
16
Headphones LED display table
Charging red LED flashing
Fully charged LED permanently lit
Switching off LED lights up one time for 1.5 sec.
Battery almost empty red LED flashing fast 3 x
Bluetooth connection mode active
(Pairing)
red and blue LED flash alternating
Bluetooth connection active blue LED flashes slowly with
interruptions of 7 sec.
Bluetooth connection lost blue LED flashes slowly with
interruptions of 3 sec.
Media playback active blue LED flashes slowly with
interruptions of 7 sec.
Incoming call blue LED flashes fast with interruptions
of 1 sec.
Call active blue LED flashes slowly with
interruptions of 7 sec.
Playback device settings for best wireless sound
To achieve the best possible Bluetooth sound with Amiron, consider the following
practical hints:
• Set the volume of the Amiron to minimum, of the playback device to maximum. From
then on, adjust the volume on the Amiron only, not on the playback device. This applies
only to playback devices that do not automatically synchronise the volume.
• On playback devices that automatically synchronise the volume (e.g. iPhone, iPad,
various Android smartphones), the headphones volume is always identical to the
volume of the playback device.
• Deactivate any audio effects that might exist in your player software.
• Ensure that aptX™ HD is switched on at the Amiron wireless, if supported by your
playback device.