ply pressure (R version) or “0” (S version).
6 - MAINTENANCE
To allow the machine to work correctly, follow the
maintenance instructions provided below.
6.1 Safety rules
Do not subject the machine to water jets.
Disconnect the machine from the electrical
power by turning the electrical power network
omnipolar knife-switch lever to the resting
position 0. Remove the plug and close the
water interception tap before carrying out
maintenance and/or cleaning work. If the
machine is malfunctioning, do not attempt to
repair it alone and call the technical assistance
service immediately. If the electrical power
cable has been damaged, turn off the machine
immediately, turn off the water and call the
technical assistance service. Do not replace
it alone. Carry out cleaning/maintenance
when the machine is cold, preferably wearing
protective gloves.
6.2 Cleaning the machine
These recommendations are indicative.
Maintenance and cleaning frequency depends on
machine use.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and filters
Daily
1) Clean the cup holder grill and drain tank
2) Clean the machine body
Weekly
1) Clean the unit seal with the brush provided (Fig.
07).
2) Clean the water tank.
3) Wash the unit as follows: attach the filter holder
to the unit with the blind filter provided (Fig. 09;
pos. 16) and start up distribution several times.
Monthly
1) Submerge the filter holders and filters in boiling
water for a few minutes to dissolve coffee grease,
use a cloth or sponge to remove residue.
Do not use solvents, detergents or
abrasive sponges for washing and
cleaning. Clean the machine body with
a cloth dampened in water and/or neutral
detergents, carefully drying surfaces before
reconnecting the machine to the power supply. Use
water to clean the cup holder grill and drain tank.
Use water and neutral detergents to clean the tank
after removing it. When finished rinse thoroughly.
6.3 Safety thermostat - Manual re-
arming
Warning! The operation
described below is only relevant
to an installing technician who is
authorised by the manufacturer.
While the machine is working, the boiler resistance
may overheat and, cutting off power, sets off the
safety thermostat that prevents any further damage
to the boiler. To restore normal operations, resolve
the malfunction that triggered the safety thermostat
and restore normal conditions by pressing the red
button (RESET) (Fig. 08).
6.4 Correct product disposal
(electrical and electronic waste)
(Applicable in the European Union countries and
those countries with separate waste collection
systems).
The sign carried on the product or on its
documentation indicates that the
product must not be disposed of with
other domestic waste at the end of its life
cycle. To avoid any damage to the environment or
to health, caused by unsuitable waste disposal, the
user is asked to separate this product from other
types of waste and to recycle it responsibly to help
the sustainable recycling of material resources.
Domestic users are invited to contact the dealer
where the product was purchased or the local
office in charge of this matter for all the information
relating to separate waste collection and recycling
for this type of product.
Company users are invited to contact their own
supplier to check the terms and conditions of the
purchase contract.
This product must not be disposed of together with
other commercial waste.
To Next Page
Loading...
