BFC CLASSICA EVA - Tea Dispensing Pump Activation; Steam Boiler Control Panel Assignment; Display Steam Wand Temperature

VU001_1010_Rev000_ISTRUZ_DOSAT_3D5_MAESTRO_CLASSICAEVA_TEC
Area Elettronica
Page | 5
11. PRESS BUTTON 5 “P” AGAIN TO MOVE ON TO THE NEXT SETUP. THE
DISPLAY SHOWS “ Tea with pump “ . THIS FUNCTION STARTS THE PUMP
WHEN THE TEA BUTTON IS PRESSED. PRESS BUTTON 1 ( YES ) TO ENABLE
OR BUTTON 2 ( NO) TO DISABLE. PRESS BUTTON 5 “P“ TO CONFIRM.
12. THE DISPLAY SHOWS “ Steam boiler Gr “ . THIS IS AN OPTIONAL FUNCTION.
THIS FUNCTION ENABLES THE DESIRED CONTROL PANEL, WHICH
CONTROLS THE STEAM UNIT. PRESS BUTTON 1 ( NEXT 0-1-2-3 ) OR BUTTON
2 ( BACK 3-2-1-0 ) . PRESS BUTTON 5 “P“ TO CONFIRM.
13. CONTINUING TO PRESS THE BUTTON 5 "P" YOU GO TO NEXT SELECTION.
THE DISPLAY WILL SHOW "Disp. Steam Wand". THIS FUNCTION IS ON ONLY
WHEN YOU DECIDE WHICH KEY-PUSH BUTTON USE FOR STEAM PIPE (SEE
SECTION 12), AND ALLOWS YOU TO VIEW ON THE DISPLAY THE
TEMPERATURE (EXPRESSED IN DEGREES CELSIUS OR FAHRENHEIT) OF
STEAM PIPE. AT THIS POINT PRESS THE 1 (ENABLE) TO ENABLE O 2
(DISABLE) TO DISABLE FUNCTION. TO CONFIRM PRESS 5 "P".
Tea with pump
NO
Steam boiler Gr.
0
Disp.Steam Wand
DISABLED