T: 07 4779 1740 F: 07 4725 6228
W: www.mcgovernagencies.com.au E: admin@mcgovernagencies.com.au
1/324 Bayswater Rd Garbutt P0 Box 7526 Garbutt Q 4814
While the display is off pressing the (+) button will open the gate. Pressing the (-
) button will close the gate.
When gate is at full open or closed, read the screen. If the gate is closed and
screen says SUC the direction is correct. If it says SUO, you need to reverse the
direction. This is in LOGIC menu (see page 3).
TO GET INTO PROGRAMMING
Press OK 3 times QUICKLY, screen should read PARAN
Use (-) button until screen says LING, use (-) and (+) button till screen says
LANG
PRESS OK
Use (-) and (+) button until screen says LOGIC
Press OK
Screen will say TCA
Press OK
Press (-) and (+) until screen says 1(one)
Press OK
Press (-) and (+) until screen says StEP- by-StEP
Press OK the limits before clipping to rack
Press (-) and (+) until screen says 1 (one)
Press OK
To Next Page
Loading...
