T: 07 4779 1740 F: 07 4725 6228
W: www.mcgovernagencies.com.au E: admin@mcgovernagencies.com.au
1/324 Bayswater Rd Garbutt P0 Box 7526 Garbutt Q 4814
IF YOU WANT A SECOND BUTTON TO OPEN THE GATE
Press (-) and (+) simultaneously till screen says Add Start
** Press (-) and (+) until screen says Add2ch
Press ok
Screen says hiddEn bUtton
Press the 2 top buttons on the remote control at the same time. After
approximately 2 seconds the LED will come on, release the buttons.
The screen will now say dEsirEd bUtton
Press the button on the remote you want to use for 2 secs. (RH) screen will say
OK 01
Repeat from step ** for next remote.
Screen will say OK02 etc. for extra remotes
SETTING LIMITS AND AUTOSET
Press (-) and (+) simultaneously until screen says RADIO
Press (-) and (+) until screen says AUtoSEt
Put gate into manual by opening front bottom lever, you may need the key.
CLOSE the gate manually and lock it back in.
Press OK. Motor will count down 3, 2, 1 then start opening. It may open /
close a few times and then say OK
Press (-) and (+) simultaneously twice until the gate says end
Now you are ready to operate the gate press the remote and see what happens.
When you press remote to open, gate should open fully. Likewise when closing.
While opening, if you press remote again, motor will stop.
To Next Page
Loading...
