SW-Stahl und Werkzeugvertriebs GmbH Tel. +49 (0) 2191 / 46438-0
F 56 essartS resukreveL ax +49 (0) 2191 / 46438-40
ed.lhatsws@ofni :liaM-E diehcsmeR 79824-D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
3.3. MAINS POWER ELECTRICAL SAFETY (In relation to the battery charger)
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with
the following:
- Ensure that the insulation on cables is safe before connecting it to the power supply.
- Do not pull or carry the appliance by the power cable.
- Do not use worn or damage cables, plugs or connectors. Immediately have any faulty item
repaired or replaced by a qualified electrician.
3.4. BATTERY CHARGER SAFETY INSTRUCTIONS
- WARNING! Do not attempt to charge any battery other than that supplied for the cordless tool.
Other types of batteries may explode!
- Disconnect the charger from the mains supply when not in use.
- Do not charge battery if room temperature is below 10°C (50°F) or above 40°C (104°F).
- Do not expose the charger to damp or wet conditions.
- Do not pull or carry the charger by the power lead.
- Do not operate the charger if it has been dropped, or has received a sharp knock, or is damaged.
Take the charger to an authorised agent for repair or obtain a replacement.
- Do not dismantle the charger as this may cause damage and personal injury and will invalidate
the warranty.
- Do not insert foreign objects or material into the hole reserved for the battery pack.
- Do not recharge a second battery pack immediately after charging the first. Consecutive charging
will overheat the charger. Allow the unit to cool for 15 minutes before charging the next pack.
- Do not attempt to connect two chargers together.
- Store the charger in a same manner as the battery pack.
4. OPERATING INSTRUCTIONS
4.1. PARTS DESCRIPTION
Shaft Lock
2
On / Off / Speed Controller
3
10,8V Battery
4
Battery Retaining Clip
5
Velcro Adapter
CHARGER
Charger not connected
to main voltage
Charger is connected
to main voltage
Battery is charging
Battery has charged
fig.2
fig.1
fig.3
fig.4
fig. 1