SW-Stahl und Werkzeugvertriebs GmbH Tel. +49 (0) 2191 / 46438-0
F 56 essartS resukreveL ax +49 (0) 2191 / 46438-40
ed.lhatsws@ofni :liaM-E diehcsmeR 79824-D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
4.2. CHARGING THE BATTERY PACK
4.2.1. Remove the battery pack from the wrench, by depressing the two side retaining clips (fig.1).
WARNING! Do not touch metal terminals.
4.2.2. Place the cordless tool to side and take the battery charger.
4.2.3. The battery pack and charger have the positive (+) and negative (-) terminals marked. Align
the correct terminals and insert the battery into slot (fig.3 & 4).
Note: The battery pack is designed so that it will only enter the charger unit the correct way.
When placed in the charger, a very slight downward pressure will seat the pack firmly into the
power terminals.
4.2.4. Connect the charger to mains supply; red LED lights (fig.3).
Charging begins.
4.2.5. When charging is complete, the red LED goes out and the green LED lights (fig.4). The battery
is now ready to use. Note: When new, the battery pack will have been shipped in a low charge
state. It will take longer to charge initially, and several subsequent charges may also take a
little longer than when the battery pack reaches its optimum performance. Normal charging
time is approximately 1 hour.
4.2.6. After removing the battery, disconnect the charger from the mains supply and store it for
safekeeping in a dry place.
4.2.7. Make sure that the speed controller is in position 0 before connect the battery to polishing
machine.
4.3. USING POLISHING MACHINE
4.3.1. Warning: Fix the Velcro adapter (fig.1.5.) before first use. Press the shaft lock (Fig.1.1.) and
rotate the Velcro adapter until the lock is latched. Now the Velcro adapter can be fixed by
turning clockwise. It is enough to tighten the Velcro adapter by hand. Release the shaft lock
and check whether the Velcro adapter can rotate freely.
4.3.2. Fit the battery pack to the cordless tool by aligning the tongue on the battery with the groove in
the housing and slide it into place. Ensure that the battery pack is firmly located, you will hear
an audible click when it has locked into position.
4.3.3. Select the required pad and insert it centered on the Velcro adapter.
4.3.4. Set the desired speed by turning the speed controller (fig.1.2).
4.3.5. To remove the Velcro adapter (fig.1.5.), press the shaft lock (fig.1.1) and turn it counter
clockwise.
5. MAINTENANCE
Keep the outer case of the cordless tool clean and free from grease.
Do not wash with water or use solvents or abrasives. Use a damp cloth.
For any other service or maintenance, contact your authorised service agent.
6. DISPOSAL
Never disposal the batteries or cordless tool with your domestic waste.
Collect worn out batteries or electrical appliances and recycle them
at your local collecting point or give it to your dealer.
To Next Page
Loading...
Need help?
General