BGW 250 - Technical Specifications

2- SPECIFICATIONS
TIle following specifications are guarranteed mInImum perfor-
mance levels, not typical or best cnse numbers measured under
ideal conditions. All test procedures used are according to
the most conservative techniques in use today.
POWEK OUTPUT: 8S-watts average continuous power per channel
at 8-ohms.
FRf,QIJENCY R[SPONSE:
+0-0.25 dB 201lz to 20KHz
+0-3 dB 211z to 65 Kllz
HARMONIC DISTORTION:
Less than 0.1% at 85 watts per cnannel or less into 8 ohms.
1M DISTORTION: (00 & 7khz 4:1):
Less than .l~ at 85 watts per channel or less into 8 ohms.
tfUM & NOISE (20-20 kHz):
105 dB below HS watts into 8 oj~s
INPUT SENSITIVITY:
I volt +2% for 20 volts out (SO watts, 8 ohms)
voltage-gain of 26 db (20xL 1.5 volts required for full outpuL
INPUT H!PEDANCE:
47,000 ohms
DAMPING FACTOR:
Greater than 500 at low frequencies (8 ohms )
OUTPUT LOAD H1PEDANCE:
Designed for any load impedance greater than 2 ohms.
Haximum
output po'veT occllrs rtt 2 ()l'r~.
RISE TIMBrIO-90t):
5 micro5cconds- inuicat.ing a bandwidth of (IS KlIz.