acoustician.
Select the most
comfortable
volume for you by
rotating the volume
control. The volume
will become louder by
turning it clockwise, or
quieter by turning it anti-
clockwise.
Please note:
Please make absolutely sure that your
contact mini wearing system is positioned
correctly on the head and that the conductor
plate of the bone conduction receiver rests
against the head. Please make sure that the
conductor plate is touching the skin.
• Hair between the conductor plate and the
skin may reduce transmission considerably.
• Poor contact with the skin and a high
volume may cause feedback.
Set the M-T switch to "T" to hear directly,
without the interference of the microphone
and disruptive noises.
It is also possible to select a combined mi-
crophone/telecoil mode using the fitting
software. This mode enables you to receive
inductive signals whilst also hearing your
environment better as the microphone is
switched on. The device is supplied with the
combined mode M/T.
3. Setting the volume
Adjust the volume of the contact mini by
turning the blade of screwdriver no. 1 on
the volume control (electronic component).
Please consult your doctor or hearing aid
acoustician about the ideal volume for you.
Please ensure that you are properly informed
by your doctor or hearing aid acoustician as
regards setting the volume, and do not ad-
just the volume of your contact mini without
the agreement of your doctor or hearing aid
To Next Page
Loading...