7
4.
Preset target temperature “SP” & Purging working time St
Running
mode: after the oven is first turned on, controller will be in running mode.
Setting mode: hold and “Set” button for
6 seconds in running mode to enter into the setting mode.
Controller will return to running mode automatically if no action is taken in 60
seconds.
4-1. Setting target temperature and dwelling time
1. Plug in power cable, switch on circuit breaker in the back and turn on the oven.
2. Press ‘Set’ button once, controller will display “SP”, now use “Shift”, “Decrease” or “Increase”
button to set
your target
temperature.
3. Press ‘Set’ again to confirm, controller will display “St”, now use “Shift”, “Decrease” or “Increase” button to set dwelling time
in minutes (you can set it to display in hours with the “Hn”
setting). Oven starts timing the
first time actual temperature reaches target temperature. If “St” is
set to zero, oven will
continue to run at target temperature until turned off manually.
4. Press ‘Set’ again to confirm all settings.
5. When dwelling time is up, the controller will
display “End” and buzz for 60 seconds. It can be
muted by pressing any button.
6. Press and hold “Reset” for 3 seconds to restart oven operation.
7. During heating, if alarm is set and actual temperature is over that limit, buzzer will sound continuously and “ALM” light will
come on. Press any key to mute it.
Prompts Names
Description
Sp
St
Target Temperature value
Dwelling time
range Default
value
Amb+10℃～100℃
0-9999 (0) minutes
Single point control set temperature(℃)
0 = continuous heating, use code “Hn” to
change unit
To Next Page
Loading...