10
How To Use
Administering Butane
1. Once the tube has been frozen, simply insert the butane into the port
on the top and fill it to the necessary capacity
2. Once you have administered the necessary amount, let the tube sit for
between 10-30 minutes.
(Note: the longer it is let to sit, the higher the yield will be, however the
clarity and quality will also lower.)
How To Use
Removing the final product
1. After the tube has been let to sit, you can begin to collect your
product. Place a container under the quadpod (Such as a pyrex dish).
Next, slowly open the bottom valve to allow oil/butane solution to
fill the container.
The endcap at the top of the tube can be removed at his point.
(See The included specifications If your unsure)
To Next Page
Loading...