11
How To Use
Removing Your Solvent
1.Now you have your oil/solvent soulution, the solvent can be removed.
Place the container into a warm water (Aprox 40-60°C). This will cause
the majority of the solvent to evaporate out of you oil.
Once the solution begins to stop bubbling, enough butane has been
removed to go on to the final process.
2.Now the last remnants of solvent can be extracted. Place your oil into
either a Vacuum Oven/Chamber.
(If your using a chamber it will need to be used with a heat mat,
available from the website).
The combination of heat and pressure from a vacuum will result in all the
solvant left being pulled out of the oil.
(This process should take a minimum of 48 hours, including flipping the
product half way through)
After this process is complete, your final product is now ready.
To Next Page
Loading...