BIC 960 - Important Amendments and Cartridge Notes; Nylon Screw and Insulator Usage

IMPORTANT!
©O©
Amendment to all BIC Owner’s Manuals
This unit is supplied with four pairs of
nylon screws which are — W" — Vi " —
in length. Use only the nylon screws
supplied when mounting the cartridge
and choose the correct length as per
the owner’s manual.
Packed with the screws is a special
insulator. The insulator must be
installed beneath the cartridge as per
the illustration. Both the nylon screws
and insulator are non-conductive.
If this insulator is not used,
or if the metal cartridge mounting
screws are used, hum will exist.
DISREGARD ANY INFORMATION IN
THE OWNER’S MANUAL
CONCERNING “REMOVAL OF THE
GROUND STRAP FROM THE
CARTRIDGE”.
Illustration shows pickup head used in Models
1000, 980 and 960. On the 920 and 940, mount
in the same manner.
Due to their extreme length, certain
Ortofon cartridges may interfere with the
wiring harness in the pickup head. A
special adaptor, Part No. 37-120-01, is
available from B4*C to raise the
cartridge above the harness.
28-114-01