BIC 960 - Spare Parts

Spare Parts
Re-install the Turntable
Retaining “C” Clip
The turntable "C" clip has a projection on
both the top and botfom. THIS PROJEC¬
TION MUST FIT FULLY INTO THE SLOT
OF THE TURNTABLE SPINDLE (Fig. F,
page 12).
Lubrication
All pivot points and bearing surfaces
have been lubricated at the factory and
will seldom, if ever, require further
attention. Should lubrication be
required, we recommend this be
performed by B-l-C or one of its
authorized service stations. If you prefer
doing this yourself, we recommend
you purchase a Technical Service
Manual which provides full details and
explicit instructions on this entire
subject.
Record Care
Keep the cartridge and stylus clean
and replace if worn. Periodically have
the stylus inspected by your dealer.
Return all records to their protective
sleeves and jackets. Do not leave records
on the turntable for long periods, if not
in use.
Store vertically rather than horizontally
or flat. If possible, store records at
average room temperatures. Do not
permit them near or in contact with heat
producing devices, such as radiators,
electronic equipment, amplifiers, etc.
Excessive temperatures tend to cause
warpage of records. Avoid handling the
groove surfaces as this will deposit a
film of oil on the grooves. Hold records
by their outer edges when mounting or
removing from turntable to keep
records clean.
Accessories
A-1 Plug-in Head
A-2 45 rpm Automatic adaptor (optional)
A-3 Automatic spindle
A-4 Manual spindle
A-5 50 cycle pul ley for 960
A-6 50/60 cycle strobe for 980
A-7 Elastomer drive belt
A-8 Stylus setting gauge
A-9 Shell lock nut/"C" clip/'‘0" ring.
Part Number and Description
1. 10-028-01 Tonearm assembly
2. 10-043-08 Turntable & mat assembly
with insert (960)
3. 10-043-09 Turntable & mat assembly
with insert (980)
4.10-101 -01 Record support assembly
5. 10-152-01 P/U rest post
6. 37-355-01 P/U rest lock
7. 38-386-01 Finger lift
8.39-381-01 P/U head locking nut
9. 10-026-01 Counterbalance weight
10. 38-151-01 Trim plate for shell
Items Not Shown
37-344-01 Cartridge setting gauge
37-143-01 T/T retaining clip
37-175-01 "O" ring
37-539-01 45 rpm manual adaptor
17-113-03 Stereo Audio Cable(s)
37-540-01 Isolation mount
39-602-01 60 cycle pulley
13