General Maintenance Remarks
Adjusting the height of the seat/handlebar
In order to adjust the height of the seat/handlebar you’ll have to unlock the lever that can be seen in
the pictures below, adjust the saddle/handlebar stem height to the desired position without
exceeding the mark carved onto the saddle’s tube. Lock the lever in place and you’re done.
The saddle’s height must be set so that you can place your feet at the ground comfortably.
Cleaning and Maintenance
Regular maintenance guarantees you a longer durability and road worthy state of your bike.
Maintenance includes cleaning, lubricating and ride setting adjustments. Regular maintenance work
is required to sustain a warranty claim. This applies to special corrosion (surface rust) and other
damages, which by non-observance, would not be undertaken by us. Thus, please read through the
following section thoroughly.
Frequency Component Lubricant How to Lubricate
Weekly
Brake Calipers
Brake Levers
Oil
Oil
3 drops from oil can
2 drops from oil can
Monthly Shift Levers Lithium Based Grease Disassemble
Every Six Months Freewheel
Brake Cables
Oil
Lithium Based Grease
2 squirts from oil can
Disassemble
Yearly
Bottom Bracket
Pedals
Wheel Bearings
Headset
Seat Post
Lithium Based Grease
Lithium Based Grease
Lithium Based Grease
Lithium Based Grease
Lithium Based Grease
Disassemble
Disassemble
Disassemble
Disassemble
Disassemble
Lubrication
Shaft Drive
Shaft drives operate at a very consistent rate of efficiency and performance, without
adjustments or maintenance.
To Next Page
Loading...