Biddeford Throw - Getting Started - Blanket

Getting Started - Blanket
Step 1:
Remove the warming blanket from the
package along with the controller(s).
Step 2:
Lay the warming blanket out flat, with the
connector(s) located at the bottom. The
label should be located at the bottom near
your feet, and visible.
Step 3:
Securely attach the connector cord from
the controller to the connector on the
warming blanket. Make sure that the
connection is firmly secured.
For King and Queen size warming blan-
kets, ensure both controllers are connect-
ed in order to utilize/heat both sides of
the warming blanket. Alternatively, one
connector may be connected to the side of
the warming blanket you wish to utilize/
heat. One controller controls one side.
Step 4:
Insert the power cord from the control-
ler(s) into a standard home 120V AC, 60Hz
wall outlet. Make sure the controller(s) is
not covered, that any vents in the control-
ler housing are not obstructed, and the
controller(s) is not suspended by its cords.
6 Customer Support: 800.789.6441