Biddeford Throw - Getting Started - Throw

Getting Started - Throw
Step 1:
Remove the warming throw from the
package along with the controller.
Step 2:
Lay the warming throw out flat, with its
connector located at the bottom. The label
should be located at the bottom near your
feet, and visible.
Step 3:
Securely attach the connector cord from
the controller to the connector on the
warming throw. Make sure that the con-
nection is firmly secured.
Step 4:
Insert the power cord from the controller
into a standard home 120V AC, 60Hz wall
outlet. Make sure the controller is not
covered, that any vents in the controller
housing are not obstructed, and the con-
troller is not suspended by its cords.
8 Customer Support: 800.789.6441