EasyManuals Logo

BIFFI ICON3000 Series User Manual

BIFFI ICON3000 Series
177 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #137 background imageLoading...
Page #137 background image
December 2019
129
Installation, Operation and Maintenance Manual
VCIOM-08500-EN
Appendix
Appendix
B.4 Terms and Conditions
Emerson guarantees every product to be free from defects and to conform to industry
standards. Unless otherwise specied, the warranty period is one year from the date of
installation by the rst user or eighteen months from the date of shipment to the rst
user, whichever occurs rst.
No warranty is given for products that are subject to improper storage, improper
installation, misuse, or are modied or repaired by unauthorized personnel.
Repair work resulting from improper use will be charged at standard rates.
B.5 Manufacturer's Liability
Emerson will not accept any liability in the event of:
Use of product in a fashion that contravenes local safety at work legislation.
Incorrect installation relating to, disregard for, or incorrect application of the
instructions as provided on the product nameplate and in the Installation,
Operation, and Maintenance Manual MAN-02-04-97-0713 and Appendix B within.
Modication of the product without Emerson authorization.
Work done on the product by unqualied or unsuitable personnel.
B.6 Storage and Pre-Installation
B.6.1 Storage Procedure
NOTICE
Not following the procedures according to this document will invalidate the product warranty.
Normally the optional extension for additional entry or additional electronic card
is directly mounted on the base model of ICON3000 and leaves the factory in perfect
condition. In this case, the general storage procedure as stated in Section 2 must be followed.
When the above extension is shipped separately for a eld upgrade on an existing ICON3000
unit, this extension must be stored in a protected area while ensuring that the explosion-
proof joints are well-protected and kept free of damage. The standard plastic plugs used to
protect the cable entries during transport are not explosion-proof nor water-proof; these
plugs are only intended to prevent entry of foreign objects. The extension for additional
entry/entries or additional electronic cards maintains the same weather-proof degree of
protection as the base ICON3000 model. Good operating condition can only be maintained if
the extension is correctly installed/connected on-site and if it has been correctly stored.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BIFFI ICON3000 Series and is the answer not in the manual?

BIFFI ICON3000 Series Specifications

General IconGeneral
CategoryController
SeriesICON3000
Operating Temperature-40°C to +85°C (-40°F to +185°F)
Input Signal4-20 mA
Enclosure RatingIP66, NEMA 4X
MountingDirect Mounting on Actuator
CommunicationHART
Housing MaterialAluminum

Related product manuals