To Next PageTo Next Page
Need help?Do you have a question about the BIFFI ICON-020 and is the answer not in the manual?
Safety guidelines for installing actuators in hazardous areas, including specific warnings.
Detailed steps for mounting the actuator onto the valve, including coupling types.
Guidance on connecting the actuator's electrical supply and wiring.
Specific instructions for handling and maintaining explosion-proof enclosures.
Guidelines for installing the actuator in environments with explosive dusts.
Guidelines for operating the actuator via electrical controls.
How the Emergency Shut Down signal overrides other commands.
How to access and change actuator settings using the local interface menus.
Steps to enter set-up mode, including password entry and menu navigation.
Configuration routines for stroke limits, torque, ESD, remote/local controls, etc.
Configuring opening and closing limits by position or torque.
Setting output torque limits for opening and closing.
Configuring the Emergency Shut Down action and priority.
Configuring actuator action upon loss of input signals.
Steps to diagnose and resolve issues when the electronics do not power up.
Diagnosing why the actuator does not respond to remote controls.
Safety guidelines for installing actuators in hazardous areas, including specific warnings.
Detailed steps for mounting the actuator onto the valve, including coupling types.
Guidance on connecting the actuator's electrical supply and wiring.
Specific instructions for handling and maintaining explosion-proof enclosures.
Guidelines for installing the actuator in environments with explosive dusts.
Guidelines for operating the actuator via electrical controls.
How the Emergency Shut Down signal overrides other commands.
How to access and change actuator settings using the local interface menus.
Steps to enter set-up mode, including password entry and menu navigation.
Configuration routines for stroke limits, torque, ESD, remote/local controls, etc.
Configuring opening and closing limits by position or torque.
Setting output torque limits for opening and closing.
Configuring the Emergency Shut Down action and priority.
Configuring actuator action upon loss of input signals.
Steps to diagnose and resolve issues when the electronics do not power up.
Diagnosing why the actuator does not respond to remote controls.
General| Category | Controller |
|---|---|
| Housing Material | Aluminum |
| Input Signal | 4-20 mA |
| Supply Pressure | 20-150 psi |
| Operating Temperature | -20°C to +60°C (-4°F to +140°F) |
| Enclosure Rating | NEMA 4X |
