3.8 Maintenance Record
10,000 MILE MAINTENANCE:
1. Change engine oil and lter
2. Change transmission lubricant and clean magnetic drain plug
3. Change primary drive lubricant and clean magnetic drain plug for enclosed primary
4. Check primary compensating sprocket for proper torque and adjust chain if needed
5. Inspect air cleaner and service as required
6. Inspect petcock fuel lter screen and service as required
7. Inspect fuel valve, lines and ttings for leaks
8. Check and adjust the clutch
9. Check and lubricate throw-out bearing and clutch rod (RSD only)
10. Check and adjust nal drive belt or chain for tension and wear
11. Check chain roller and tensioner condition if applies
12. Check rear brake pedal and front lever adjustment
13. Inspect brake pads and discs for wear
14. Inspect brake uid reservoir level and condition
15. Inspect oil lines and brake system for leaks
16. Lubricate brake and clutch levers and throttle and clutch cables
17. Inspect operation of throttle and enrichener controls
18. Check tire pressure and inspect for wear and damage
19. Check rear swing arm pivot nut for proper torque
20. Check all operations of electrical equipment and switches
21. Inspect and/or replace spark plugs as needed
22. Check condition of rear shock absorbers and front forks
23. Check torque of all fasteners except engine head bolts
24. Check engine idle speed adjustment
25. Inspect frame, swingarm, front and rear fenders for any cracks
26. Check ignition timing
27. Clean battery connections
28. Inspect, repack and adjust steering head bearings
29. Replace front and rear wheel bearings
DEALER WHO PERFORMED THIS SERVICE:
TECHNICIAN WHO PERFORMED THIS SERVICE:
DEALER’S ADDRESS: PHONE:
VIN: DATE: MILEAGE:
BIKE OWNER’S SIGNATURE:
To Next Page
Loading...