COLD STARTING PROCEDURE FOR ELECTRONIC FUEL INJECTED MODELS:
Make certain the bike is in neutral.
Turn ignition switch to the ON position.
Depress handlebar ENGINE STOP switch to the RUN position.
Wait a few seconds until the fuel lines are pressurized.
Depress start button for no more than ve seconds at a time until the engine starts.
Allow engine to warm approximately one to two minutes before riding.
NOTE: A battery discharges up to 2% per day when idle. If your motorcycle is not ridden for ap-
proximately for a month, the battery may not have sufcient charge to start your motorcycle.
Big Bear Choppers does not recommend using a standard automotive battery charger as battery
failure is not covered under warranty.
HOT ENGINE START:
Use the same procedure as cold start.
SHUTTING DOWN:
Use the ENGINE STOP SWITCH on the right handlebar to shut off the engine. Turn the ignition key
switch to the “OFF” position.
1.1 Starting and Stopping your Engine
To Next Page
Loading...