KEY SWITCH POSITIONS
There are two ignition key positions. When the key is horizontal, or sideways, the ignition is
OFF and you can take out the key in this position. Vertical, or up, the ignition is ON and the key
should not be able to be removed. After shutting down the engine, always turn the switch to the
OFF position. If you leave the ignition ON, the lights will run down the battery. Always lock the
ignition and remove the key from the bike when you leave. Don’t make it easy for somebody to
steel your bike. Because believe us, everyone wants your Big Bear Chopper!
ENGINE RPM CONTROL
During the break in period of your new motorcycle, gure out the relationship of the clutch and
the throttle. Try not to over-rev the engine (especially when shifting). Do not “speed shift” or shift
without using the clutch. The throttle should be closed and the clutch disengaged when shifting
gears either up or down. It’s very easy to exceed engine maximum RPM during acceleration in
rst and second gear.
The motorcycle should NOT be run for long periods at a constant RPM during the initial break in pe-
riod. Varying the RPM will help the engine during this crucial period and help prolong engine life.
1.2 Initial Break-in Procedure
CAUTION: If You Are Not An Experienced Rider,
Take Instruction from a Qualied Instructor Before
Riding Your Big Bear Chopper
To Next Page
Loading...