15. Turn on the product before opening the laser show control
software. Otherwise, the laser show control software need to be
reopened.
16. Use the original shake-proof packing for re-transportation.
17. This symbol indicates separate collection of electronics and
electronic equipment
Inspection
In order to use the product securely and properly, please read the
manual before using and follow the instructions strictly to prevent
personal safety trouble and product damage caused by misuse.
Take care of the product, check the possibility of the product damage
caused by transportation and check all the listed items are present
upon receipt of the product.
1 x LASER display system 1 x User manual 1 x DMX cable
1 x Power cable 1 x DB25 link（optional) 1 x Interlock wire
Installation
1. Make sure there is no flammable or explosive subjects within min
1.5 meter nearby the installation.
2.Before installation, please check and make sure the power supply
voltage meet request of the system.
3. Please check ventilation and fans or exhaust passages are cleared.
4. The equipment should be fixed firmly.
5. For security reasons, the appliance must be earthed.
6. Laser light above MPE should not be accessible to audience, MPE
can’t be exceed in the separation distance, see the illustration:
Instruction of using interlock wire
The machine will work only if plugging in the Interlock wire with
short circuit. It will delay 5-15 seconds to light out.
Page 2
(Attention:When in Follow Mode,either can be chosen for the Host.In
asynchronous situation,the Follow one will run after the Host
automatically to reach synchrony).
Maintenance
Clean the lens regularly. Do not use a wet cloth or chemicals, but a
cotton swab with alcohol to clean the lens. The maintenance
frequency depends on the usage frequency and surrounding working
conditions of the product. Clearance per 15 days is recommended.
Besides, dust cover at the product side should be dismantled to clear
regularly because the heat radiation effect will be affected by the dust
for the long-time use.
Warning
Power off before installation or maintenance.
Declare
The product is with good performance and complete package when it
is delivered. The end-user of this product should follow all the above
instructions and warnings. Any damage caused by misuse, malfunction
and problem caused by ignoring the instructions are not included in
the repair guarantees of the manufacturer or dealers.
All products made from Big Dipper Laser Company have anti - fake
identification. please verify the anti-counterfeit label at the bottom
of the case to ensure the interests of consumers.
Page 7
To Next Page
Loading...