BIG RED JACKS T90203B

Questions and Answers

L
Lisa WilliamsJul 29, 2025
Why BIG RED JACKS Jack will not lift load?
- B
  Brenda PhillipsJul 29, 2025
  There are several reasons why your BIG RED JACKS Jack might not be lifting the load. The release valve may not be completely closed, so ensure you turn the handle clockwise. It's also possible that the weight capacity has been exceeded. Another potential cause is air in the hydraulics, in which case you should purge air from the system. The oil level might be low, so add oil as required. Finally, the power unit could be malfunctioning, requiring a replacement.
C
christopher62Aug 3, 2025
What to do if BIG RED JACKS Jack will not hold load?
- T
  teresaelliottAug 4, 2025
  If your BIG RED JACKS Jack is not holding the load, it could be due to a few reasons. First, make sure the release valve is completely closed by turning the handle clockwise. Another possible cause is a low oil level; add oil as needed. Lastly, the power unit may be malfunctioning, and you might need to replace it.
C
cochrandennisAug 10, 2025
How to improve poor lifting of BIG RED JACKS Jack?
- S
  Scott KellyAug 10, 2025
  If your BIG RED JACKS Jack has poor lifting performance, there are a few things you can check. Air might be in the hydraulics, so try purging the air from the system. Also, the oil level could be low, so add oil as required. If neither of those solves the issue, the power unit may be malfunctioning and need replacement.
N
Nicole ArnoldAug 15, 2025
Why BIG RED JACKS Jack will not lift to full extension?
- S
  Shelby HerreraAug 15, 2025
  If your BIG RED JACKS Jack isn't lifting to its full extension, it could be due to a low oil level. Adding oil as required may solve this. Alternatively, the power unit may be malfunctioning and need to be replaced.
L
Linda FletcherAug 22, 2025
What to do if BIG RED JACKS Jack will not lower?
- J
  Joseph PowersAug 22, 2025
  If your BIG RED JACKS Jack is not lowering, it could be due to an overfilled oil reservoir; drain the excessive oil. Another cause might be that the jack is binding or there's a foreign obstruction; in this case, lubricate the moving parts.