BIGREP ONE GENERATION 3

To Next Page

To Previous Page

III. Soware BigRep

III-C Config

* 2016-04-07

› Config file defines all operational settings of the printer

› Example: Acceleration of axis, buer smoothieboard, oset, stepper values

etc

› Most of the values are not allowed to change

› Small amount of values are allowed to change and have to be changed in

case hardware is replaced (for example new extruder):

› Stepper Value Extruder (flowrate)

› Stepper Value X-Axis, Y-Axis and Z-Axis

› Oset nozzle T0-T1

› Z-Probe Oset

Part of config file

You will find the full config in VI-C Maintenance Config Overview

III-C 1/1

BIGREP ONE GENERATION 3 - III-C Config