BIGREP ONE - User Manual

Your First Print: The Toolbox
I. WHAT YOU NEED
1.
2.
3.
The Ocke Print Folder – available
here – that contains:
• The PLA 1 mm nozzle
Presetting .factory file
• The Toolbox .stl file
A spool with more than
50 g of 2.85 mm PLA filament.
Choose the color you like from
our online shop here!
Install Simplify3D.
If you don’t have a license,
get in touch with our team
at support@bigrep.com
II. SLICING
1. Open Simplify 3D
2.
3.
4.
5.
Click on File >
Open Factory File
Select the factory
file from the First
Print Folder
Click on File > Import
Model
Select “Toolbox.stl”
Double click on the model.
With the side bar you can move,
rotate or scale the object.
To obtain the best results, in this
case we recommend not to
change these values.
Double click on
the process
“Process1” to
open the
process settings
2.
4.
3.
5.

Summary

Essential Prerequisites for Your First Print

Required Print Folder Contents

Contains the .factory and .stl files needed for the first print.

PLA Filament Requirement

Specifies the need for a spool of 2.85 mm PLA filament for printing.

Simplify3 D Software Installation

Instructions for installing Simplify3D, including contact for licensing.

Simplify3 D Slicing and Preparation

Open Simplify3 D Software

Launch the Simplify3D application to begin the slicing process.

Load Factory File and Import Model

Open the .factory file and import the 'Toolbox.stl' model.

Adjust Model Settings

Guidance on moving, rotating, or scaling the 3D model as needed.

Configure Process Settings

Modify layer, infill, and other process parameters based on provided values.

Save and Prepare Print

Save the factory file and initiate the print preparation process.

Preview and Export Toolpaths

Review the slicing results and save the toolpaths (G-code) to disk.

Machine Preparation and Setup

Clean the Print Bed

Clean the print bed surface using ethanol for optimal adhesion.

Start the Machine

Power on the machine and interact with the UI controls.

Heat the Machine

Set the bed to 60°C and the extruder to 205°C for PLA printing.

Insert Filament into Extruder

Load the PLA filament into the extruder and extrude to clean the nozzle.

Printing and Post-Print Procedures

Load Print File

Insert the USB stick and load the prepared print file via the UI.

Start the Print

Home the axes and initiate the printing process once the machine is ready.

First Layer Quality Adjustment

Monitor and adjust the nozzle-to-bed distance for a perfect first layer.

Remove the Print

Allow the print to cool down before safely removing it from the bed.

BIGREP ONE Specifications

General

Build Volume	1005 x 1005 x 1005 mm
Filament Diameter	2.85 mm
Print Speed	Up to 100 mm/s
Printing Technology	Fused Filament Fabrication (FFF)
Heated Bed	Yes
Bed Leveling	Manual
Nozzle Diameter	0.6 mm
Connectivity	Ethernet, USB
Supported Materials	PLA, PETG, TPU
Software	Simplify3D
Extruder	Single