BIGREP ONE GENERATION 3 - IV-L Test Prints

IV. Setup BigRep
IV-L Test Prints
* 2016-04-07
Flow Consistency
Print G-Code Constant_flow_test_both_extruders.gcode ! Hold the result
against light and check uniformity of the Layer
Dual Extrusion Accuracy
Print Winkel_dual_extr_accuracy.gcode : both angle have to be placed exact on
above the other
When test failed:
1. Measure the oset from x,y-angle from the print object
2. Change value in config
3. T0 X-oset and T1 Y-Oset
Final Test Sample
Run oicial Testsample overnight (1mm nozzle)
Check all results - have a look at manual „check testprint“
IV-L 1/1