V. Maintenance BigRep
V-B Replacing Print Bed Tape
* 2016-04-07
Note
Both layers are bigger than necessary. So no need to be super accurate. At the
end you will cut away the overlapping tape. You can order new printbed tape at
bigrep.com/shop
Tools
› Cleaner (alcohol)
› Roller (hard)
› Knife
› 2 Persons
› 2 printbed tapes
Procedure
1. Preparation
a. Heat the table to 40°
b. Take-o the old tape
c. Clean the whole table with a strong cleaner like alcohol
d. MENTION:
THE SURFACE HAS TO BE 100% CLEAN AND DUST FREE
e. Move the Z-Axis up to about 50-80cm
2. First layer
a. You need two persons
b. Take one tape and pull o the first part of the protection film (yellow)
V-B 1/5
To Next Page
Loading...
