Need help?Do you have a question about the BIGTREETECH TFT35 and is the answer not in the manual?
General| Display Size | 3.5 inches |
|---|---|
| Resolution | 480 x 320 pixels |
| Touchscreen | Yes |
| Display Type | TFT LCD |
| SD Card Slot | Yes |
| Operating Voltage | 5V |
| Weight | 120g |
| Interface | USB |
| Compatibility | Marlin, RepRap |
| Firmware Update | SD card |
| Dimensions | 93mm x 87mm |
Details the ARM Cortex-M3 chip, dual modes, WIFI, FIL-DET, PS-ON ports, and interface options.
Lists appearance size, installation size, microprocessor, power input, and SD card logic voltage.
Explains the function of the red power indicator (D6) and green SD card detection indicator (D3).
Provides a detailed size diagram showing dimensions and port placement on the TFT35 V3.0 board.
Illustrates how to connect the display via WIFI, SD, USB, and specific interface ports.
Details how to obtain firmware from customer service or download it from the company's open source website.
Step-by-step guide on updating the firmware using an SD card, including file naming and process.
Information for users updating firmware on DIY boards, referencing a specific PIN file.
Emphasizes that the firmware file name on the SD card must not be changed.
Stresses performing wiring with power off and checking connections before powering on to prevent damage.
Highlights the importance of correct wiring sequence and non-inverted wire insertion, referencing PIN files.
To Next Page
