Need help?Do you have a question about the BIGTREETECH TFT70 V3.0 and is the answer not in the manual?
General| Resolution | 1024x600 |
|---|---|
| Touchscreen | Yes |
| Operating Voltage | 5V |
| SD Card Slot | Yes |
| USB Port | Yes |
| Processor | ARM Cortex-M3 |
| SD Card Support | Yes |
| Display Size | 7.0 inch |
| Interface | UART |
| Compatibility | Marlin |
| Display Type | LCD |
| Firmware Update | Yes |
Lists key features of the TFT70 V3.0 display screen, including MCU and compatibility.
Details physical dimensions, MCU, resolution, and power requirements of the display.
Describes the function of D6 (power) and D4 (SD card) indicator lights on the motherboard.
Provides dimensional drawings and labels for the screen and PCB layout.
How to connect EXP1 and EXP2 for compatibility with 12864 screens.
Using the RS232 port for connecting the TFT in UART screen mode.
Switching between screen modes by pressing and holding the encoder.
Methods to obtain firmware, including customer service and open source.
Steps for upgrading firmware via SD card, including file naming.
The firmware file name on the SD card must not be changed.
Pull plug before connecting; check cables to prevent damage.
Avoid connecting wrong interfaces; refer to PIN document for details.
To Next Page
