Bilanciai DD700 User Manual (English)

Other manuals for Bilanciai DD700

Manual5 pages

Quick Start4 pages

Questions and Answers:

B
Brandon FergusonAug 2, 2025
Why does my Bilanciai DD700 display backlighting turn on, but no data is displayed?
- C
  crystal70Aug 2, 2025
  If the display backlighting is on but no data is displayed on your Bilanciai Scales, it might be due to the contrast being set too low. To resolve this, switch on the terminal while holding the button pressed. After a few seconds, the display will show the "CB" logo with the contrast at maximum, after which it will gradually decrease. Release and press the button again to set the contrast to the desired level.
W
whitecynthiaAug 7, 2025
How to fix a Bilanciai DD700 terminal that does not switch on?
- V
  Vicki BarnettAug 7, 2025
  If your Bilanciai Scales terminal does not switch on, the issue is likely due to a lack of power. First, verify that power is reaching the mains outlet socket. Then, ensure that the mains lead is correctly plugged in.
A
atkinsoncheyenneAug 12, 2025
What to do if my Bilanciai DD700 display shows '- -'?
- N
  nancy75Aug 12, 2025
  If your Bilanciai Scales display shows '- -', it indicates a zeroing off-range issue upon powering up. To fix this, switch off the terminal, remove any load from the scale, and then power the terminal on again.
J
Jonathan TurnerAug 17, 2025
What to do if the Bilanciai Accessories display backlighting is on, but no data are displayed?
- S
  smithjacobAug 17, 2025
  If the display backlighting is on but no data is displayed on your Bilanciai Accessories terminal, it might be due to the contrast being set to the minimum. To adjust it, switch on the terminal while holding the button pressed. After a few seconds, the display will show the "CB" logo with the contrast at maximum, after which the contrast will gradually reduce. Release the button and then press it again to set the contrast at the required level.