USE AND MAINTENANCE MANUAL
7 TROUBLESHOOTING
If the suggested remedy does not solve the problem, contact Assistance Service.
7.1 Malfunctions
The terminal
does not switch on
Check that power arrives at
the mains outlet socket.
Check that the mains lead is
correctly plugged in.
Par. 3.2.2
The display backlighting is on,
but no data are displayed
Adjust contrast (set to minimum)
Switch on the terminal while
holding pressed .
After a few seconds, the
display will show the "CB" logo
with the contrast set to
maximum, after which the
contrast will gradually be
reduced.
Release and then press it
again to set the contrast at the
required level.
Zeroing off-range on powering
Switch off the terminal, unload
the scale then power the terminal
again.
To Next Page
Loading...
